Exacq exacqVision Edge/IQeye Quick Start Guide Manuel d'utilisateur télécharger pdf (Page 3)

www.exacq.com

Page 3 of 5

10/17/2014

Installation and Configuration

CAUTION: Do not record from an IP camera on more than one exacqVision server at a time, regardless of where exacqVision Server

is running.

1. Install the IQeye camera and insert the SD memory card in the camera.

NOTE: SD cards are normally pre-formatted to the FAT32 file system and automatically mounted when inserted. However,

you can re-format the card using the camera, if desired, by following the instructions provided by the camera manufacturer.

2. Configure the camera’s network parameters to communicate with a PC-based browser using the IQeye IQfinder utility

found on the CD shipped with the camera, or downloaded from the manufacturer website.

3. If necessary, upgrade the camera firmware to the latest version from the manufacturer website.

4. Download the latest exacqVision Client application from the Exacq website at www.exacq.com/support/downloads.html.

5. Install the client software on your computer.

6. Download the latest exacqVision Edge server application from www.exacq.com/support/downloads.html?type=edge.

7. Open a browser to the camera and log in. The default username and password are root and system.

8. Select Setup and then the DTS (Direct-To-Storage) tab (see the following illustration).

9. Ensure the Capacity for the internal SD card is greater than zero, which means the camera is communicating with the SD

card (see the following illustration).

1 2 3 4 5

Pas de commentaire

Exacq exacqVision Edge/IQeye Quick Start Guide Manuel d'utilisateur Page 3