Exacq exacqVision Virtual User Manual Manuel d'utilisateur télécharger pdf (Page 19)

www.exacq.com

+1.317.845.5710

+44.1438.310163

USA (Corporate Headquarters)

Europe/Middle East/Asia

Page 19 of 44

4/12/2013

11. Format the new drive using the mkfs command in ext4 format:

sudo mkfs.ext4 –F –L /mnt/edvr/2 /dev/sdd

NOTE: The –L portion creates a label for the new drive and should be designated as the path to the new mount point

created earlier.

The drive then formats the inode tables. Depending on the size of the drive, this could require a few minutes.

12. The fstab file must be modified to include the new disk so that it will be mounted automatically after a restart. Open

this file by using the Nano text editor, as follows:

sudo nano /etc/fstab

13. Under the last line, insert a label defining the new label used in the mkfs command. The mount point should be the

full path to mount point created previously. Be sure to follow the same syntax, as Linux is case-sensitive.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 43 44

Pas de commentaire

Exacq exacqVision Virtual User Manual Manuel d'utilisateur Page 19